Owon HDS-N Series Uživatelský manuál stáhnout pdf (Strana 66)

OWON HDS-N Series Handheld DSO & DMM 8-Advanced Function of Oscilloscope

When log out submenu, every value will show on the right bottom of the screen as figure 55:

Figure 55: Use the Cursor for a Time Measurement

8.11.2 Setting the cursor measurement in FFT mode

FFT being on, the cursor measurement menus are listed and described in the following table.

Function menus Settings Description

Type

OFF

Range

Frequency

Close the cursor measurement.

Display the vamp measurement cursor and menu.

Display the freq measurement cursor and menu.

Source

CH1，CH2

isplay the selected source in the FFT MODE menu,

unable to change here.

Delta

Display the difference of measured value between the two

channels

Curs1 Display the relating measured value of Cursor 1

Curs2 Display the relating measured value of Cursor 2

To make a range measurement on CH1, doing the following:

1. Press the MENU key and the function menus are displayed at the right of the screen.

2. Press the MENU ▲ or MENU ▼ key to select CURS MEAS. Five options are shown at the

bottom of the screen.

3. Press F1 key to select the measurement type Range. Two purple crossing dashed lines V1

and V2 are shown on the screen.

4. The channel which FFT operates is the measured channel CH1.

5. Press OPTION and display as

—

Cursor 1

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 87 88

Žádné komentáře

Owon HDS-N Series Uživatelský manuál Strana 66